Submit Articles

Ebay Listing Templates Generator

Next I carefully machined the binding on  using the pressed in crease as a guide. I went very slowly and eased  everything in around the curves as you can probably tell by the intense  way I’m hunched over the sewing machine. The binding then gets turned over the raw  edges and clipped in place before being hand sewn down on the back of the pocket. I’m  using a felling stitch here for strength. With the binding complete I started work on  the waistband. I had to piece my fabric to get a length long enough to make the waistband so I  started by join, clipping and pressing that seam. I then pressed the waistband where it had gotten  a little warped from tearing it along the grain before fusing.

Should You Build Your Own eBay Template

The foldaband to the  sateen. This is sometimes called slotted interfacing and I use it often to  make things like plackets and waistbands. With the foldaband on I could attach  the pocket to the waistband along the top edge. The pattern gave instructions for where to position the pocket on the waistband so I measured and pinned to the correct ebay template distance before stitching it on. Then with right sides together I stitched the  ends of the waistband before grading the seam allowance so that when I turned the waistband right side out I would get a crisp corner. I then folded the waistband to the  correct width along the perforations in the foldaband and using my topstitching  foot stitched the waistband in half. When I got to the section that would sandwich  the pocket in place I made sure to stitch very carefully so that everything  was caught securely in position.

 

I realised at this point I had completely forgotten about this pattern piece for the scissors holster so I decided to make it from the  wool check and some cotton drill scrap I had in my stash. The pattern didn’t call for a lining but  I knew the wool would need some reinforcement. I joined the two pieces along the  top edge with right sides together. As the wool was very bulky I edge stitched  the seam allowance in place so I could get a nice finish across that top edge. This was  difficult to do along the curved seam. It also wasn’t actually that successful so I decided  just to topstitch the top edge as well. I then folded the holster in half with wrong sides together and stitched the layers together along the outside edge. I trimmed away any excess seam allowance and then zig-zagged over the raw edges to prevent fraying.  Then the scissors holster was complete. The next step required my least  favourite craft tool, a hot glue gun. To make the pincushion I ran a gathering stitch around the edge of the circle that would create the top of the pincushion. I then gathered it  up slightly, lined it with batting and then began stuffing it with scrap fabric cut into little  pieces. This was incredibly time-consuming and took much more fabric than I had expected. I was  very glad of my ergonomic scissors I tell you. Once I had enough fabric



Article USA
Logo
Shopping cart